The Land Pride RTA1242, RTA1250, RTA1258, RTA1266, RTA1274 & RTA1282 Rotary Tillers till soil for seedbed or planting preparation with uses in both rural and non-rural applications like gardening and landscaping. The offset capabilities allow the tiller to work closer to objects such as fence lines, buildings, or trees. Operator can control the tilling depth with the adjustable skid shoes. A 15" rotor swing diameter turns the soil over faster, and enables deep tilling action. NOTE: Quick-Hitch may require a longer driveline, which is available through Land Pride Parts.
Available Models: RTA1242, RTA1250, RTA1258, RTA1266, RTA1274, RTA1282
Note: Some feature photos may be represented by a similar model and not the specific model shown on this page.
Our Quick-Hitch System allows you to quickly connect and disconnect from the implement - most without leaving the tractor seat. This is a real time saver when working on multiple projects.
3 Year Limited Gearbox Warranty demonstrates our confidence in the gearbox's quality and lasting performance.
10 Year Chain & Sprocket Warranty
Land Pride’s proven chain and sprocket drive system are among the most reliable in the industry. To prove it we are offering: Year 1, the warranty covers parts and labor, Years 2 through 10 are parts only.
Stamped Chain Case
Stamped forming gIves the chain cover strength.
Cast iron gearbox provides durability.
4 ‘C’ shaped heat-treated tines per flange. “C” Shaped tines require less hp to move through the ground. Four tines requires less horsepower than 6 tine
Why does my Tiller make a clacking noise when I raise it out of the ground?
This is most likely caused by putting the driveline in too much of an angle causing the u-joints to rub against one another. Raise the tiller while in operation just enough to clear the ground.
What type of oil is in the chain case and in the gearbox?
The chain case has 00 flowable grease (Corn head grease) and the gearbox has 80-90 wt. gear lube.
How fast can I run the tiller?
It depends on the conditions, but 2-3 mph is about the right speed. You may need to slow down if you start to notice material building in front of the machine.
How do I slip the clutch?
A step by step procedure is located in the Operator’s Manual (manual can be found on Related Products Page below). It is imperative that this be done prior to operation and any time the unit has set idle.